![]() |
A most difference of exchanging routes between RIP v1 and V2
1 Attachment(s)
According to the topology above, configure BB1 and R1 to exchange RIP routes via unicast.
|
Knowledge Points
RIP V2 supports exchanging route using unicast ( by default, RIPv1 uses broadcast and RIPv2 uses multicast).
To enable the unicast update, do the followings:
In this case, set BB1’s E0/0 and R1’s E1/1 to the passive mode, so they will not send the RIP information out by broadcast. Then enable the unicast update to exchange the route information. In this case, set BB1’s E0/0 and R1’s E1/1 to the passive mode, so they will not send the RIP information out by broadcast. Then enable the unicast update to exchange the route information. |
All times are GMT -4. The time now is 09:19 AM. |
Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
Copyright © 2009 NetBrain, Inc. All rights reserved.