The Net-Brainer

The Net-Brainer (http://forums.netbraintech.com/index.php)
-   One-Skill-at-a-Time (http://forums.netbraintech.com/forumdisplay.php?f=18)
-   -   How to configure NAT to redirect the outside traffic? (http://forums.netbraintech.com/showthread.php?t=627)

David.C 11-05-2009 11:08 PM

How to configure NAT to redirect the outside traffic?
 
1 Attachment(s)
According to the figure above, configure R6 such that for all traffic from outside network towards 11.11.6.254,

* if it is telnet, re-direct to R3's lo0;
* if it is http, re-direct to R3's s0/0

David.C 11-05-2009 11:12 PM

Re: Knowledge Points
 
Knowledge Points:

To configure the NAT, taking the following steps:

1. Define the internal and external network for the NAT.
(config-if)#ip nat inside Specify the internal interface.
(config-if)#ip nat outside Specify the external interface.

2. Configuring the source IP address to be translated.

Static mapping
(config)#ip nat inside source static Local_ip _addr global_ip_addr

Dynamic mapping
(config)#ip nat inside source [ list { 1-99 } | route-map ] pool pool_name overload

3. Configuring the dynamic address pool for overload NAT
(config)#ip nat pool netbrain begin_IP end_IP netmask mask


All times are GMT -4. The time now is 08:41 AM.

Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
Copyright 2009 NetBrain, Inc. All rights reserved.