The Net-Brainer

The Net-Brainer (
-   One-Skill-at-a-Time (
-   -   EIGRP is NOT working ? (

Chris 06-17-2009 01:27 AM

EIGRP is NOT working ?
Cisco gurus,
I am trying to setup EIGRP protocol on two routers via point to point through serial 0.0. Iíve set the AS as the same group and entered in the networks. But when I try to show the neighborhood i cant see anything...its not exchanging any packets at all...Any help will be great. Iíve been at this for hours and figure I'd try it out on here.

David.C 06-17-2009 05:04 AM

EIGRP is classful by default
After seeing your configs and network prefixes I'd say that the issue is the fact that EIGRP is classful by default.

By default your network command configures those interfaces in the network to participate in the EIGRP process.

You need to add the same mask (or equivalent wildcard mask) used on the interfaces after the network command.
Similarly, adding no auto-summary may also resolve the problem.

All times are GMT -4. The time now is 09:45 PM.

Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
Copyright © 2009 NetBrain, Inc. All rights reserved.