The Net-Brainer

The Net-Brainer (http://forums.netbraintech.com/index.php)
-   One-Skill-at-a-Time (http://forums.netbraintech.com/forumdisplay.php?f=18)
-   -   How to connect a incontinuous area to the backbone area in OSPF (http://forums.netbraintech.com/showthread.php?t=464)

David.C 08-28-2009 05:00 AM

How to connect a incontinuous area to the backbone area in OSPF
 
1 Attachment(s)
According to the figure above, configure the serial interfaces of R3 and R6 as OSPF area 36

David.C 08-28-2009 05:02 AM

Re: OSPF Virtual-link
 
Knowledge Points:

In the multi-area OSPF network environment, each non-backbone area must be directly connected to the backbone area (though this connection could be a logical connection such as a virtual link).

Virtual-link is used to connect two disconnected backbone areas, or connecting a backbone area with a non-backbone area across a common neighbor area.

In this case, configure a virtual-link on SW1 and R6, so that Area 36 could connect to Area 0 via Area 167.


All times are GMT -4. The time now is 09:53 AM.

Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
Copyright 2009 NetBrain, Inc. All rights reserved.