Home NetBrain Product One-Skill-at-a-Time Search Mark Forums Read
Go BackThe Net-BrainerNetBrain Product How to set the management IP as a reachable IP address

Thread Tools Search this Thread Display Modes
Old 12-25-2012, 08:05 PM
NetBrainTAC NetBrainTAC is offline
Join Date: Dec 2012
Posts: 521
Default How to set the management IP as a reachable IP address

Problem: You may find some devices are unreachable in NetBrain but actually they can be accessed.

Root Cause: NetBrain pick up the first accessible IP address as management IP during discovery. If in the future, that IP/interface is shutdown, then, netBrain has no live access to that device.

Solution: For devices without any device settings, Tune live access will auto set the management based on interface type, starting from Loopback, then Ethernet/vlan/serial/&, as long as the 1st IP is accessible via ping/snmp.

Applicable to: All devices

Note: It will take time to run the tune live access for whole workspace. You can run it based on selected device group, or from the q-map during the troubleshooting, right click on the map > Tune live access, it will only tune the devices in the map, so you can quickly collect all data you needed during troubleshooting time.
Reply With Quote


Consultant Edition, Operator Edition, Personal Edition

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Forum Jump

All times are GMT -4. The time now is 10:13 AM.
Powered by vBulletin
Copyright 2000-2010 Jelsoft Enterprises Limited.
Copyright 2009 NetBrain, Inc. All rights reserved.