Netbrain
Home NetBrain Product One-Skill-at-a-Time Search Mark Forums Read
Go BackThe Net-BrainerOne-Skill-at-a-Time How to customize the advertised routes of RIP while redistributing?

Reply
 
Thread Tools Search this Thread Display Modes
Old 07-16-2009, 11:40 PM
David.C David.C is offline
 
Join Date: May 2009
Posts: 118
Default How to customize the advertised routes of RIP while redistributing?


Preview Qmap: "RIP Policy Redistribution .qmap"


According to the topology above, configure R1 to redistribute the routes learned from BB1 into OSPF, make sure only the three routes appeared in BB1 route table gets redistributed.
Attached Files
File Type: qmap RIP Policy Redistribution .qmap (30.0 KB, 0 views)

Last edited by David.C; 11-20-2009 at 08:24 AM.
Reply With Quote
Old 07-16-2009, 11:53 PM
David.C David.C is offline
 
Join Date: May 2009
Posts: 118
Default Knowledge Points

To match the exact routes, you should define the condition via an extended ACL list, and then apply them to the route-map.

Verify via:

SW1#show ip route ospf
O E1 199.172.11.0/24 [110/101] via 11.11.17.1, 00:09:14, FastEthernet0/1
11.0.0.0/8 is variably subnetted, 3 subnets, 2 masks
O 11.11.1.1/32 [110/2] via 11.11.17.1, 00:09:39, FastEthernet0/1
150.100.0.0/24 is subnetted, 1 subnets
O E1 150.100.0.0 [110/101] via 11.11.17.1, 00:09:14, FastEthernet0/1
150.1.0.0/24 is subnetted, 1 subnets
O E1 150.1.11.0 [110/101] via 11.11.17.1, 00:09:14, FastEthernet0/1
Reply With Quote
Reply

Bookmarks

Tags
CCIE

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Forum Jump

All times are GMT -4. The time now is 12:28 PM.
Powered by vBulletin
Copyright 2000-2010 Jelsoft Enterprises Limited.
Copyright 2009 NetBrain, Inc. All rights reserved.