Netbrain
Home NetBrain Product One-Skill-at-a-Time Search Mark Forums Read
Go BackThe Net-BrainerOne-Skill-at-a-Time How to configure CRP and receive multicast stream in multicasting

Reply
 
Thread Tools Search this Thread Display Modes
Old 10-23-2009, 03:39 AM
Chris Chris is offline
 
Join Date: Jun 2009
Posts: 74
Default How to configure CRP and receive multicast stream in multicasting


Preview Qmap: "Mulitcast over frame-relay.qmap"


According to the topology above, configuring multicasting (PIM Sparse-mode) over Frame-Relay. Set R3 as the Candidate RP, and enable R4 to receive the multicasting stream of 224.4.4.4 for testing.
Attached Files
File Type: qmap Mulitcast over frame-relay.qmap (41.5 KB, 0 views)

Last edited by Chris; 11-20-2009 at 06:50 AM.
Reply With Quote
Old 10-23-2009, 03:44 AM
Chris Chris is offline
 
Join Date: Jun 2009
Posts: 74
Default Knowledge Points

  • (config-if)#ip pim nbma-mode
    To enable multicasting in NBMA network
  • (config)#ip pim send-rp-announce Loopback0
Scope TTL group-list ACL-list Configuring the current router to advertise as the Candidate RP using Loopback interface
  • (config)#ip pim send-rp-discovery scope TTL
    Set the current as the RP Mapping Agent
Reply With Quote
Reply

Bookmarks

Tags
CCIE, CCNP, Network Design, Routing

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Forum Jump

All times are GMT -4. The time now is 06:01 AM.
Powered by vBulletin
Copyright 2000-2010 Jelsoft Enterprises Limited.
Copyright 2009 NetBrain, Inc. All rights reserved.