Home NetBrain Product One-Skill-at-a-Time Search Mark Forums Read
Go BackThe Net-BrainerNetBrain Product Custom Parser for Cisco Nexus Mac Address Table?

Thread Tools Search this Thread Display Modes
Old 09-10-2019, 10:14 AM
transam101 transam101 is offline
Join Date: Sep 2019
Posts: 1
Default Custom Parser for Cisco Nexus Mac Address Table?

Gents (and ladies),

Per some of the other posts I've read, it seems like the QAPP sharing center was decommissioned, so not sure if this is the proper forum for this question or not.

However, I'm looking for a simple parser that would gather table data from a 'show mac address' command against a Cisco Nexus 9K router. I don't have a lot of experience in writing parsers, but from the few I did, I have not run into the issue where the direct underneath column data is not properly associated with the proper column header (like with this case). In the included picture, you can see I have the mac address column defined as a variable, but the 'type' field (most of which are dynamic values) are showing up under the mac address column. I'm not sure how to correct this without writing my own Python script, but that seems overkill to gather a simple table from the switch.
Attached Images
File Type: jpg parserchoke.jpg (52.2 KB, 11 views)
Reply With Quote
Old 10-10-2019, 09:48 PM
NetBrainTAC NetBrainTAC is offline
Join Date: Dec 2012
Posts: 526
Default Re: Custom Parser for Cisco Nexus Mac Address Table?

Reply With Quote


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Forum Jump

All times are GMT -4. The time now is 09:38 PM.
Powered by vBulletin
Copyright 2000-2010 Jelsoft Enterprises Limited.
Copyright 2009 NetBrain, Inc. All rights reserved.