Netbrain
Home NetBrain Product One-Skill-at-a-Time Search Mark Forums Read
Go BackThe Net-BrainerOne-Skill-at-a-Time EIGRP is NOT working ?

Reply
 
Thread Tools Search this Thread Display Modes
Old 06-17-2009, 01:27 AM
Chris Chris is offline
 
Join Date: Jun 2009
Posts: 74
Default EIGRP is NOT working ?

Cisco gurus,
I am trying to setup EIGRP protocol on two routers via point to point through serial 0.0. Iíve set the AS as the same group and entered in the networks. But when I try to show the neighborhood i cant see anything...its not exchanging any packets at all...Any help will be great. Iíve been at this for hours and figure I'd try it out on here.
Reply With Quote
Old 06-17-2009, 05:04 AM
David.C David.C is offline
 
Join Date: May 2009
Posts: 118
Default EIGRP is classful by default

After seeing your configs and network prefixes I'd say that the issue is the fact that EIGRP is classful by default.

By default your network 192.168.0.0 command configures those interfaces in the 192.168.0.0/24 network to participate in the EIGRP process.

You need to add the same mask (or equivalent wildcard mask) used on the interfaces after the network 192.168.0.0 command.
Similarly, adding no auto-summary may also resolve the problem.
Reply With Quote
Reply

Bookmarks

Tags
CCNP

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Forum Jump

All times are GMT -4. The time now is 07:57 AM.
Powered by vBulletin
Copyright © 2000-2010 Jelsoft Enterprises Limited.
Copyright © 2009 NetBrain, Inc. All rights reserved.