Home NetBrain Product One-Skill-at-a-Time Search Mark Forums Read
Go BackThe Net-BrainerNetBrain Product Multi Context ASA

Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old 07-02-2018, 09:44 AM
clownbootz clownbootz is offline
Join Date: Jul 2018
Posts: 1
Default Multi Context ASA


For some reason I cannot get NetBrain to see all the contexts on Cisco ASAs. I have logging and the right SSH and SNMP creds in NetBrain, but it still only show the System and admin context. I saw another post in this forums where it was recommended to check the perms of SNMP and SSH and to make sure "Retrieve inventory information of Device/Module/Interface" which I did. It also said that NetBrain uses the command show context to discover other contexts. Well after running the discovery again I exported the log file and noticed it did not run that command. It runs show name, enable, show failover, show route, and exit. Can you please advise on how to get other contexts to show in NetBrain?
Reply With Quote


Network Discovery

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Forum Jump

All times are GMT -4. The time now is 12:15 PM.
Powered by vBulletin
Copyright 2000-2010 Jelsoft Enterprises Limited.
Copyright 2009 NetBrain, Inc. All rights reserved.