 |
 |
 |
|
|
|
 |
|
|
Thread Tools | Search this Thread | Display Modes |
08-28-2009, 06:00 AM
|
|||
|
|||
How to connect a incontinuous area to the backbone area in OSPF
Preview Qmap: "OSPF Virtual-link .qmap" According to the figure above, configure the serial interfaces of R3 and R6 as OSPF area 36 Last edited by David.C; 12-03-2009 at 11:28 PM. 
|
|
08-28-2009, 06:02 AM
|
|||
|
|||
|
Re: OSPF Virtual-link
Knowledge Points:
In the multi-area OSPF network environment, each non-backbone area must be directly connected to the backbone area (though this connection could be a logical connection such as a virtual link). Virtual-link is used to connect two disconnected backbone areas, or connecting a backbone area with a non-backbone area across a common neighbor area. In this case, configure a virtual-link on SW1 and R6, so that Area 36 could connect to Area 0 via Area 167.
|
|
| Bookmarks |
| Tags |
| CCIE, OSPF, Routing |
| Thread Tools | Search this Thread |
| Display Modes | |
|
Linear Mode
