Home NetBrain Product One-Skill-at-a-Time Search Mark Forums Read
Go BackThe Net-BrainerNetBrain Product Discovery without SNMP access?

Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old 05-30-2013, 05:44 PM
smelias smelias is offline
Join Date: May 2013
Posts: 1
Default Discovery without SNMP access?


I'm running the eval of netBrain Consultant and wanted to know if I could perform a typical L3/L2 discovery of a datacenter switch block with out using SNMP? (ie: just using CLI).

I tried it and it seemed to pickup on the switch (l3) however the down stream L2 switches / topology doesn't appear to be in the map.

Also the mac to IP to DNS doesn't appear to be picking up.

Can I perform a L3/L2 discovery build a map with vlans, and port trunks etc... using only the CLI.

btw - we're using cisco nexsus gear as well if that helps
Reply With Quote


CCIE, CCNA, CCNP, Consultant Edition, Network Design, Network Discovery, Network Troubleshooting

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Forum Jump

All times are GMT -4. The time now is 08:53 PM.
Powered by vBulletin
Copyright © 2000-2010 Jelsoft Enterprises Limited.
Copyright © 2009 NetBrain, Inc. All rights reserved.